Accessory 265V Cord Connected Kit

Lodging

ac.com

Javascript is required to properly view this site. Please turn on your JavaScript now.

Frequently Asked Questions

	LodgingAC

Installation > Accessory 265V Cord Connected Kit

Question:
How do I install the accessory 265V cord connected kit?

Answer:
Packaged Terminal Air Conditioner or Heat Pump
7,000 to 14,000 Btuh

Accessory 265-V Cord-Connected Kit

Installation Instructions

Part No. PLUG-265V-15AMP PLUG-265V-20AMP PLUG-265V-30AMP

SAFETY CONSIDERATIONS
Installing, starting up, and servicing air-conditioning equipment can be hazardous due to system pressures, electrical components, and equipment location.

Only trained, qualified installers and service technicians should install, start up, and service this equipment.

When working on air-conditioning equipment, observe precautions in the literature and on tags, stickers, and labels attached to the equipment.

Follow all safety codes. Wear safety glasses and work gloves. Use care in handling equipment.

Accessory265VCord

ELECTRIC SHOCK HAZARD
To avoid the possibility of electrical shock, open all disconnects before installing or servicing this equipment.

Accessory265VCord

GENERAL
These instructions cover the installation of the accessory cord-connected kit for 265-v packaged terminal air conditioners or heat pumps. Use this kit when electric plug and receptacle are used as an alternative to a hard-wire application. Kit contains a plug and cord assembly (with access cover plate) and one screw. (Screw part no. AL79AU216.)

IMPORTANT: The cord-connected unit requires an accessory subbase, part no. SUB-BASE, with a field-supplied receptacle. See Table 1 and Fig. 1.

Accessory265VCord

FIGURE 1 - SUBBASE ASSEMBLY

INSTALLATION

WARNING
Disconnect all power to unit to avoid possible electrical shock during installation. Place unit in OFF position.

1. Install accessory subbase according to accessory instructions.
2. Remove front panel of unit according to instructions shipped with unit.
3. Remove one screw attaching smaller access cover plate to control box. See Fig. 2.

Accessory265VCord

FIGURE 2 - LOCATION OF ACCESS COVER AND CONTROL BOX SCREWS

4. Remove 2 screws on front of control box cover. See Fig. 2. Save screws for later use. Swing cover down to open control box. This provides access to unit amp connector. See Fig. 3.

Accessory265VCord

FIGURE 3 - UNIT AND CORD-CONNECTED KIT AMP CONNECTORS

5. Pass end of cord-connected kit amp connector through cover hole in control box cover. See Fig. 3.
6. Plug 2 amp connector ends together. See Fig. 3. Reattach access cover plate to control box cover with one screw provided in accessory cord-connected kit. See Fig. 2.
7. Close control box cover and use 2 screws removed in Step 4 to refasten.
8. Install receptacle outlet in subbase location shown in Fig. 1.

Accessory265VCord

FIGURE 1 - SUBBASE ASSEMBLY

9. Plug service cord end of accessory into subbase. See Fig. 2.
10. Replace front panel of unit.
11. Turn power on. Start unit according to instructions shipped with unit.


Return to Top	View Printable Version