Accessory Stamped Aluminum Grille

Lodging

ac.com

Javascript is required to properly view this site. Please turn on your JavaScript now.

Frequently Asked Questions

	LodgingAC

Installation > Accessory Stamped Aluminum Grille

Question:
How do I install the Accessory Stamped Aluminum Grille?

Answer:
Accessory Stamped Aluminum Outdoor Grilles Installation Instructions

Part No. GRILLE-ALU-STAMP

INTRODUCTION
These instructions cover the installation of accessory stamped aluminum outdoor grilles, part no. GRILLE-ALU-STAMP, for use with wall sleeves for packaged terminal air conditioners and heat pumps.

IMPORTANT: Improper installation of accessory grille could result in condenser (outdoor) air re-circulation. This will degrade performance and shorten product life of major unit components. Manufacturer does not assume responsibility for improper installation of grille.

BEFORE INSTALLATION
1. Remove sleeve center support. See Fig. 1. If chassis is not to be installed at this time, save sleeve center support. If chassis is to be installed at this time, discard sleeve center support.

AccessoryStampedAluminumGrill

FIGURE 1 - WALL SLEEVE WITH SLEEVE CENTER SUPPORT

2. Remove rear closure panel by pulling side flaps toward center of sleeve and then firmly pulling rear panel toward front of sleeve.
3. Discard rear closure panel.

INSTALLATION
1. Hold grille with top edge up (marked on inside of top edge). The foam strip should be on the indoor side, facing towards you. See Fig. 2.

AccessoryStampedAluminumGrill

FIGURE 2 - LOCATION OF SEALS

2. Insert top of grille into space provided along the inside of top rear of sleeve. See Fig. 3. Swing bottom of grille to the rear until it drops into space provided along bottom rear of sleeve. See Fig. 4.

AccessoryStampedAluminumGrill

FIGURE 3 - INSERTING STAMPED ALUMINUM GRILLE INTO WALL SLEEVE

AccessoryStampedAluminumGrill

FIGURE 4 - GRILLE SECURED IN WALL SLEEVE

3. If chassis is not to be installed at this time, reinstall sleeve center support retained from Step 1 of the Before Installation section.
4. If chassis is to be installed, refer to installation instructions shipped with chassis.


Return to Top	View Printable Version