Accessory Hard Wire Kit
Installation Instructions
Part No. H/W-KIT-265V
Installing, starting up, and servicing air-conditioning equipment can be hazardous due to system pressures, electrical components, and equipment location.
Only trained, qualified installers and service technicians should install, start up, and service this equipment.
When working on air-conditioning equipment, observe precautions in the literature and on tags, stickers, and labels attached to the equipment.
Follow all safety codes. Wear safety glasses and work gloves. Use care in handling equipment.
These instructions are for the installation of the accessory junction box assembly hard wire kit for permanently connecting 265-v packaged terminal air conditioner units. The accessory is required for 265-v units. If a non-electrical accessory subbase (see Step 8) is needed for support of the unit, it must be ordered separately from the factory.
Accessory Kit Contents - One flexible conduit assembly with covered junction box and male amp connector plug.
Disconnect all power to unit to avoid possible electrical shock during installation.
1. Disconnect all power to unit.
2. Remove front panel of air conditioner or heat pump according to instructions shipped with unit.
3. Remove wiring access opening cover plate from bottom front of control box. See Fig. 1. Discard cover plate; save screw for use in Step 5.
Because the chassis is heavy, to avoid the possibility of personal injury or equipment damage, you should obtain help when removing and lifting the chassis.
1. Disconnect all power to unit.
2. Remove the front panel.
3. Unscrew and detach hard wire kit cover plate. See Fig. 2.
4. Disconnect the plug connections.
5. Remove the 4 screws securing chassis to wall sleeve (2 screws in each side angle).
6. If unit includes the accessory lateral duct kit, remove 2 screws on top of the duct adapter.
7. Slide unit out of sleeve.